1967-1969 Camaro, Firebird, F-body Housing and Axle Package with Aluminum Center Section, Truetrac Posi, No Brakes
- Stock width 60" wheel mounting surface to wheel mounting surface
- Custom width available at no additional cost
- 9" New hybrid housing
- 3" tubes / 1/4" wall - seamless DOM
- Moser bolt-in style axles 1541H
- 31 Spline axles
- 1 Piece sealed ball bearings
- 5 x 4 3/4 bolt pattern
- Torino ends, common 2 1/2" brake offset, 2.771" hub
- Access Holes
- Bare Finish
- Shown in optional Moser Red powder coat - +$450 Upgrade
- Black +$275 Upgrade Available
Center Section
- Moser Aluminum Through Bolt
- 31 Spline Truetrac Posi
- Aluminum Daytona Support
- 1350 Yoke
- Choice of Gear Ratio
- Gear & Posi Setup in Case
Ships in 3 boxes by Ground. Looking for a fully assembled rear? We have them available also!
Housing takes a Ford 9" center section. Axle bearings are common Ford 88128 found at any part store.
If you would like to narrow this rear, powdercoat the housing, use a different bolt pattern, or use other housing ends and disc brakes we can accommodate your needs. Reach out to us and we will get you a custom quote.
Any questions, leave a note or contact us a 260-301-2424.
1967-1969 Camaro, 9" Ford, 31 Sp., Aluminum Case, Truetrac, Moser Engineering
Ford 9" housing with brackets
Specify width and offset in Notes if custom or click stock
Axles are 1541H
Axles have 2.771" hub and access holes unless specified otherwise
Housing comes with 1/4" thick tubes, Torino ends, 2 1/2" brake offset