1978-1987 G-Body Quick Performance Fab Can Housing and Axle Package
Grand National, GNX, T-Type, Monte Carlo, Grand Prix, Cutlass, Regal, El Camino, Malibu, LeMans
- Stock width wheel mounting surface to wheel mounting surface
- Ears, control arm brackets, spring cups welded on housing
- Fill Hole, Drain Plug, Jack Pad
- Rubber bushings in ears
- Quick Performance 9" FAB Housing
- 3" tubes / 1/4" wall - seamless DOM
- 31 spline QP bolt-in style axles
- 1541H American Made Axles
- Sealed ball bearings
- 5 x 4 3/4" bolt pattern
- 1/2-20 Studs
- Torino ends, common 2 1/2" brake offset, 2.771" hub, and access holes
- DISCLAIMER: This rear REQUIRES aftermarket brakes. No rear end manufacturer make a factory G-Body housing end. Stock brakes will not work on G-Body aftermarket rears.
Center Section:
- Yukon Iron Case
- Helical Gear Driven Posi
- Aluminum Daytona Pinion Support
- 1350 Yoke
- Choice of Gear Ratio
- Gear/Posi are Setup in the Center Section
Need Brakes? We use a Big Ford New Style Torino Housing End with an industry standard 2 1/2" Offset. Check out Torino Brake Kits to see options we have availbe to insure fitment.
Housing takes standard 9" center section. Axle bearings are common Ford 88128 found at any part store. 2.500" OD / 1.500" ID Inner Housing End Seals included.
If you would like to narrow this rear, use a different bolt pattern, add coil over mounts to fit your suspension, hold the shipment at your local terminal, we can accommodate your needs. Reach out to us and we will get you a custom quote.
You can expect an estimated 4 build time. Contact us if you need a rear faster.
Ships in 3 boxes by Ground. Housing, axle, and center section.
Sales tax only applies to Indiana residents.
Any questions, leave a note or contact us a 260-301-2424.